Comparison of two- and three-dimensional measurement of the Cobb angle in scoliosisReport as inadecuate




Comparison of two- and three-dimensional measurement of the Cobb angle in scoliosis - Download this document for free, or read online. Document in PDF available to download.

International Orthopaedics

, Volume 41, Issue 5, pp 957–962

First Online: 05 December 2016Received: 05 September 2016Accepted: 21 November 2016DOI: 10.1007-s00264-016-3359-0

Cite this article as: Lechner, R., Putzer, D., Dammerer, D. et al. International Orthopaedics SICOT 2017 41: 957. doi:10.1007-s00264-016-3359-0

Abstract

PurposeThe Cobb angle as an objective measure is used to determine the progression of deformity, and is the basis in the planning of conservative and surgical treatment. However, studies have shown that the Cobb angle has two limitations: an inter- and intraobserver variability of the measurement is approximately 3–5 degrees, and high variability regarding the definition of the end vertebra. Scoliosis is a three-dimensional 3D pathology, and 3D pathologies cannot be completely assessed by two-dimensional 2D methods, like 2D radiography. The objective of this study was to determine the intraobserver and interobserver reliability of end vertebra definition and Cobb angle measurement using X-rays and 3D computer tomography CT reconstructions in scoliotic spines.

MethodsTo assess interoberver variation the Cobb angle and the end vertebra were assessed by five observers in 55 patients using X-rays and 3D CT reconstructions. Definition of end vertebra and measurement of the Cobb angle was repeated two times with a three-week interval. Intraclass correlation coefficients ICC were used to determine the interobserver and intraobserver reliabilities. 95% prediction limits were provided for measurement errors.

ResultsIntraclass correlation coefficient ICC showed excellent reliability for both methods. The measured Cobb angle was on average 9.2 degrees larger in the 3D CT group 72.8°, range 30–144 than on 2D radiography 63.6°, range 24–152.

ConclusionsIn scoliosis treatment it is very essential to determine the curve magnitude, which is larger in a 3D measurement compared to 2D radiography.

KeywordsCobb angle Scoliosis Three-dimensional measurement Interobserver, intraobserver reliability 



Author: Ricarda Lechner - David Putzer - Dietmar Dammerer - Michael Liebensteiner - Christian Bach - Martin Thaler

Source: https://link.springer.com/







Related documents