Bionic Design for Mars Sampling Scoop Inspired by Himalayan Marmot ClawReport as inadecuate




Bionic Design for Mars Sampling Scoop Inspired by Himalayan Marmot Claw - Download this document for free, or read online. Document in PDF available to download.

Applied Bionics and Biomechanics - Volume 2016 2016, Article ID 5713683, 9 pages -

Research Article

Key Laboratory of Bionic Engineering, Ministry of Education, Jilin University, Changchun 130022, China

School of Mechatronics and Engineering, East China Jiaotong University, Nanchang 330045, China

Aerospace System Engineering Shanghai, Shanghai 201108, China

Received 3 May 2016; Revised 20 October 2016; Accepted 23 October 2016

Academic Editor: Estefanía Peña

Copyright © 2016 Long Xue et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

Cave animals are often adapted to digging and life underground, with claw toes similar in structure and function to a sampling scoop. In this paper, the clawed toes of the Himalayan marmot were selected as a biological prototype for bionic research. Based on geometric parameter optimization of the clawed toes, a bionic sampling scoop for use on Mars was designed. Using a 3D laser scanner, the point cloud data of the second front claw toe was acquired. Parametric equations and contour curves for the claw were then built with cubic polynomial fitting. We obtained 18 characteristic curve equations for the internal and external contours of the claw. A bionic sampling scoop was designed according to the structural parameters of Curiosity’s sampling shovel and the contours of the Himalayan marmot’s claw. Verifying test results showed that when the penetration angle was 45° and the sampling speed was 0.33 r-min, the bionic sampling scoops’ resistance torque was 49.6% less than that of the prototype sampling scoop. When the penetration angle was 60° and the sampling speed was 0.22 r-min, the resistance torque of the bionic sampling scoop was 28.8% lower than that of the prototype sampling scoop.





Author: Long Xue, Rong Rong Zhang, Wei Zong, Jia Feng Song, and Meng Zou

Source: https://www.hindawi.com/



DOWNLOAD PDF




Related documents