A Printed Monopole Antenna for Triple-Band WLAN-WiMAX ApplicationsReport as inadecuate




A Printed Monopole Antenna for Triple-Band WLAN-WiMAX Applications - Download this document for free, or read online. Document in PDF available to download.

International Journal of Antennas and Propagation - Volume 2015 2015, Article ID 254268, 7 pages -

Research ArticleNational Key Laboratory of Antennas and Microwave Technology, School of Electronic Engineering, Xidian University, No. 2 South Taibai Road, Xi’an, Shaanxi 710071, China

Received 4 July 2014; Accepted 9 January 2015

Academic Editor: Tamer S. Ibrahim

Copyright © 2015 Huiqing Zhai et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

A new compact design of monopole antenna for triple-band WLAN-WiMAX applications with two band-notches based on broadband antenna is presented. By introducing a stub loaded ground and two new paper clip structures etched on radiation patch, a compact overall dimension 31 mm 33 mm 1 mm and three separated operating bands effectively covering 2.4-5.2-5.8 GHz WLAN bands and 2.5-3.5-5.5 GHz WiMAX bands can be achieved. Compared with familiar U type slot, the introduced compact paper clip structure can save about 37% of dimension regions, which could effectively improve efficiency of band-notch formation. Simulated and measured results demonstrate that the proposed antenna has good dipole-like radiation characteristics with appreciable gain across the operating bands. Besides, main parameters of the two etched paper clip structures are investigated to control the positions and bandwidths of the two stop-bands, respectively, on basis of which the three working bands can be adjusted independently.





Author: Huiqing Zhai, Lu Liu, Zhihui Ma, and Changhong Liang

Source: https://www.hindawi.com/



DOWNLOAD PDF




Related documents