Effect of Ar-CH4 Mixture Ratio on Properties of Ag-C:H Nanocomposite Prepared by DC SputteringReport as inadecuate




Effect of Ar-CH4 Mixture Ratio on Properties of Ag-C:H Nanocomposite Prepared by DC Sputtering - Download this document for free, or read online. Document in PDF available to download.

Advances in Materials Science and EngineeringVolume 2013 2013, Article ID 142450, 6 pages

Research Article

Department of Physics, North Tehran Branch, Islamic Azad University, Tehran 1667934783, Iran

Department of Physics, Islamic Azad University, Karaj 31485313, Iran

Plasma Physics Research Centre, Science and Research Branch, Islamic Azad University, Tehran 1477893855, Iran

Received 8 June 2013; Accepted 20 July 2013

Academic Editor: Mahmood Ghoranneviss

Copyright © 2013 E. Mohsen Soltani et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

Ag-C:H films were deposited by DC sputtering method on Si substrates with different Ar-CH4 gas mixture ratios. Effect of Ar-CH4 gas mixture ratios was investigated on optical and structural properties of Ag-C:H films by FTIR spectroscopy analysis, X-Ray diffractometry XRD, scanning electron microscopy SEM, and atomic force microscopy AFM, respectively. In order to evaluate the effect of gas flow ratio on the optical and structural properties of Ag-C:H films, Ar-CH4 gas ratio was changed by keeping the Ar flow rate constant while varying the CH4 gas flow rate 2, 5, and 10 SCCM. From FTIR analysis it was observed that increase in the Ar-CH4 gas ratio results in decreasing the sputtered Ag nanoparticles and increasing of C–H bonds. Also from XRD pattern it was found that intensity of Ag crystalline plane and average grain size decrease by adding CH4 to working gas admixture. From SEM and AFM micrographs, size of the grains also became smaller on the surface of the films, which will lead to decreasing the roughness of the deposited thin films.





Author: E. Mohsen Soltani, Z. Ghorannevis, and M. Shirazi

Source: https://www.hindawi.com/



DOWNLOAD PDF




Related documents