Investigation of Corrosion Behaviour of Aluminium Alloy Subjected to Laser Shock Peening without a Protective CoatingReport as inadecuate




Investigation of Corrosion Behaviour of Aluminium Alloy Subjected to Laser Shock Peening without a Protective Coating - Download this document for free, or read online. Document in PDF available to download.

Advances in Materials Science and EngineeringVolume 2015 2015, Article ID 705306, 9 pages

Research ArticleFaculty of Mechanical Engineering, University of Ljubljana, Askerceva Cesta 6, 1000 Ljubljana, Slovenia

Received 29 September 2015; Revised 15 November 2015; Accepted 16 November 2015

Academic Editor: Ying Li

Copyright © 2015 U. Trdan and J. Grum. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

The effect of shock waves and strain hardening of laser shock peening without protective coating LSPwC on alloy AA 6082-T651 was investigated. Analysis of residual stresses confirmed high compression in the near surface layer due to the ultrahigh plastic strains and strain rates induced by multiple laser shock waves. Corrosion tests in a chloride environment were carried out to determine resistance to localised attack, which was also verified on SEM-EDS. OCP transients confirmed an improved condition, that is, a more positive and stable potential after LSPwC treatment. Moreover, polarisation resistance of the LSPwC treated specimen was by a factor of 25 higher compared to the untreated specimen. Analysis of voltammograms confirmed an improved enhanced region of passivity and significantly smaller anodic current density of the LSPwC specimen compared to the untreated one. Through SEM, reduction of pitting attack at the LSPwC specimen surface was confirmed, despite its increased roughness.





Author: U. Trdan and J. Grum

Source: https://www.hindawi.com/



DOWNLOAD PDF




Related documents