Tensile Mechanical Properties and Strengthening Mechanism of Hybrid Carbon Nanotube and Silicon Carbide Nanoparticle-Reinforced Magnesium Alloy CompositesReport as inadecuate




Tensile Mechanical Properties and Strengthening Mechanism of Hybrid Carbon Nanotube and Silicon Carbide Nanoparticle-Reinforced Magnesium Alloy Composites - Download this document for free, or read online. Document in PDF available to download.

Journal of NanomaterialsVolume 2012 2012, Article ID 851862, 7 pages

Research Article

State Key Laboratory of Structural Analysis for Industrial Equipment, Department of Engineering Mechanics, Faculty of Vehicle Engineering and Mechanics, Dalian University of Technology, Dalian 116024, China

School of Materials Science and Engineering, Dalian University of Technology, Dalian 116024, China

Received 1 February 2012; Revised 10 June 2012; Accepted 25 June 2012

Academic Editor: Tianxi Liu

Copyright © 2012 Xia Zhou et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

AZ91 magnesium alloy hybrid composites reinforced with different hybrid ratios of carbon nanotubes CNTs and silicon carbide SiC nanoparticulates were fabricated by semisolid stirring assisted ultrasonic cavitation. The results showed that grains of the matrix in the AZ91-CNT + SiC composites were obviously refined after adding hybrid CNTs and SiC nanoparticles to the AZ91 alloy, and the room-temperature mechanical properties of AZ91-CNT + SiC hybrid composites were improved comparing with the unreinforced AZ91 matrix. In addition, the tensile mechanical properties of the AZ91 alloy-based hybrid composites were considerably improved at the mass hybrid ratio of 7 : 3 for CNTs and SiC nanoparticles; in particular, the tensile and yield strength were increased, respectively, by about 45 and 55% after gravity permanent mould casting. The reason for an increase in the room-temperature strength of the hybrid composites should be mainly attributable to the larger hybrid ratio of CNTs and SiC nanoparticles, the coefficient of thermal expansion CTE mismatch between matrix and hybrid reinforcements, the dispersive strengthening effects Orowan strengthening, and the grain refining Hall-Petch effect.





Author: Xia Zhou, Depeng Su, Chengwei Wu, and Liming Liu

Source: https://www.hindawi.com/



DOWNLOAD PDF




Related documents