Prediction Model of Mechanical Extending Limits in Horizontal Drilling and Design Methods of Tubular Strings to Improve LimitsReport as inadecuate




Prediction Model of Mechanical Extending Limits in Horizontal Drilling and Design Methods of Tubular Strings to Improve Limits - Download this document for free, or read online. Document in PDF available to download.

Mathematical Problems in Engineering - Volume 2017 2017, Article ID 2968231, 18 pages - https:-doi.org-10.1155-2017-2968231

Research Article

School of Aerospace Engineering, AML, Tsinghua University, Beijing 100084, China

MOE Key Laboratory of Petroleum Engineering, China University of Petroleum, Beijing 102249, China

Correspondence should be addressed to Wenjun Huang

Received 15 February 2017; Revised 27 April 2017; Accepted 3 May 2017; Published 24 May 2017

Academic Editor: Mohammed Nouari

Copyright © 2017 Wenjun Huang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

Mechanical extending limit in horizontal drilling means the maximum horizontal extending length of a horizontal well under certain ground and down-hole mechanical constraint conditions. Around this concept, the constrained optimization model of mechanical extending limits is built and simplified analytical results for pick-up and slack-off operations are deduced. The horizontal extending limits for kinds of tubular strings under different drilling parameters are calculated and drawn. To improve extending limits, an optimal design model of drill strings is built and applied to a case study. The results indicate that horizontal extending limits are underestimated a lot when the effects of friction force on critical helical buckling loads are neglected. Horizontal extending limits firstly increase and tend to stable values with vertical depths. Horizontal extending limits increase faster but finally become smaller with the increase of horizontal pushing forces for tubular strings of smaller modulus-weight ratio. Sliding slack-off is the main limit operation and high axial friction is the main constraint factor constraining horizontal extending limits. A sophisticated installation of multiple tubular strings can greatly inhibit helical buckling and increase horizontal extending limits. The optimal design model is called only once to obtain design results, which greatly increases the calculation efficiency.





Author: Wenjun Huang, Deli Gao, and Yinghua Liu

Source: https://www.hindawi.com/



DOWNLOAD PDF




Related documents